Cutting force model in ball-end milling /
This paper presents the development, verification and implementation of the model of analytical simulation for the prediction of cutting forces jn ball-end milling. The ball-end milling is used for machining the freely shaped surfaces such as dies, moulds, turbines, propellers, and for the aircraft...
Shranjeno v:
| Main Authors: | , |
|---|---|
| Format: | Book Chapter |
| Jezik: | English |
| Teme: | |
| Sorodne knjige/članki: | Vsebovano v:
Zbornik radova |
| Oznake: |
Označite
Brez oznak, prvi označite!
|
| Izvleček: | This paper presents the development, verification and implementation of the model of analytical simulation for the prediction of cutting forces jn ball-end milling. The ball-end milling is used for machining the freely shaped surfaces such as dies, moulds, turbines, propellers, and for the aircraft structural elements. The analytical model for simulation of cutting forces consist of the mechanistic model and statistical model. The mechanistic model is based on chip load, cut geometry and the relationship between cutting forces, chip load, cutting force coefficients and cutting parameters. A model building procedure is based on experimentally obtained average forces. The existing knowledge about the cutting forces gives support in planning of the process, in selecting of suitable cutting conditions for reduction of excessive wear, deformation and breakage of the tool. |
|---|---|
| Fizični opis: | Str. 7-8. |